Washing Machines & Dryers
Vacuums & Floor Care
Humidifiers & Dehumidifiers
Roofing & Ventilation
Plastering & Drylining
Cements & Aggregates
Timber & Sheet Material
Ladders & Scaffolding
Paint & Stains
Cooling & Heating
Lawn & Garden
Outdoor Power Equipment
Fencing & Decking
Outdoor & Landscape Lighting
Timer & Lighting Controls
Windows & Doors
A water butt is used to store rainwater. Environmentally friendly and a way to lower your water charges, use this guide to help you install your own water butt at home.
Choose a downpipe that is in a suitable location to connect to your new water butt. The effectiveness of your new butt may be improved by linking it to a pipe that relieves several gutters of rainwater.
Select the side of the water butt closest to the downpipe and drill a suitably sized hole in this side, about 8-10cm from the top.
Secure the hose connector through this hole. Place the water butt on its stand, positioned about 30cm from the downpipe. Ensure it is placed high enough to allow a small container to collect water from its tap comfortably.
Mark the level of the bottom of the hose connector on the downpipe. Measure about 25cm above this position on the downpipe and mark it again. Use your hacksaw to cut the downpipe at these two marks to remove a 25cm section.
Insert the rainwater diverter in place of the removed section of downpipe. Attach as per manufacturer’s guidelines.
Attach the flexible hose from the diverter kit to both connections in the downpipe and the water butt respectively.
Tip: keep the lid of the water butt closed at all times to prevent debris falling in and insects laying eggs in the water.